ADDER A.I.M. User's Guide download pdf (Page 59)

INSTALLATIONCONFIGURATIONOPERATION

FURTHER

INFORMATION

INDEX

RADIO FREQUENCY ENERGY

All interface cables used with this equipment must be shielded in order to maintain

compliance with radio frequency energy emission regulations and ensure a suitably high

level of immunity to electromagnetic disturbances.

European EMC directive 2004/108/EC

This equipment has been tested and found to comply with the limits for a class A

computing device in accordance with the specications in the European standard

EN55022. These limits are designed to provide reasonable protection against harmful

interference. This equipment generates, uses and can radiate radio frequency energy

and if not installed and used in accordance with the instructions may cause harmful

interference to radio or television reception. However, there is no guarantee that

harmful interference will not occur in a particular installation. If this equipment does

cause interference to radio or television reception, which can be determined by turning

the equipment on and off, the user is encouraged to correct the interference with one

or more of the following measures: (a) Reorient or relocate the receiving antenna.

(b) Increase the separation between the equipment and the receiver. (c) Connect

the equipment to an outlet on a circuit different from that to which the receiver is

connected. (d) Consult the supplier or an experienced radio/TV technician for help.

FCC Compliance Statement (United States)

This equipment generates, uses and can radiate radio frequency energy and if not

installed and used properly, that is, in strict accordance with the manufacturer’s

instructions, may cause interference to radio communication. It has been tested and

found to comply with the limits for a class A computing device in accordance with

the specications in Subpart J of part 15 of FCC rules, which are designed to provide

reasonable protection against such interference when the equipment is operated in a

commercial environment. Operation of this equipment in a residential area may cause

interference, in which case the user at his own expense will be required to take whatever

measures may be necessary to correct the interference. Changes or modications not

expressly approved by the manufacturer could void the user’s authority to operate the

equipment.

Canadian Department of Communications RFI statement

This equipment does not exceed the class A limits for radio noise emissions from digital

apparatus set out in the radio interference regulations of the Canadian Department of

Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites

applicables aux appareils numériques de la classe A prescrites dans le règlement sur le

brouillage radioélectriques publié par le ministère des Communications du Canada.

1 2 ... 54 55 56 57 58 59 60 61

No comments

ADDER A.I.M. User's Guide Page 59