ADDER A.I.M. User's Guide download pdf (Page 7)

INSTALLATIONCONFIGURATIONOPERATION

FURTHER

INFORMATION

INDEX

CONNECTIONS

The A.I.M. server unit is supplied fully pre-loaded and permits no local user interaction.

All conguration takes place remotely via the network connections and as a result only

two connections are required: Network and power.

Note: If an existing A.I.M. server must be replaced, follow the important advice given within

Appendix C (Swapping out an A.I.M. server).

Network connections

The A.I.M. server has two network connections on the rear panel, labeled 1 and 2.

These allow the unit to be connected to internal and external network connections as

required. The external network connection allows admin users located away from the

internal network to be able to login.

To connect the internal IP network port

1 Run a category 5, 5e or 6 link cable from the appropriate hub or router to the A.I.M.

server unit.

2 Connect the plug of the link cable into the IP port labeled

1 on the rear panel of

the A.I.M. server unit.

COM 3

INDOOR USE ONLY

12V

Category 5, 5e or 6 cable

from LAN / network switch

Power supply connection

Important: Please read and adhere to the electrical safety information given within the Safety

information section of this guide. In particular, do not use an unearthed power socket or

extension cable.

To connect the power supply

1 Attach the output connector of the power supply (country specic power supplies are

available) to the power input socket on the left side of the rear panel.

2 Connect the main body of the power supply to a nearby earthed mains outlet.

The unit has no power switch so it will begin its

booting process as soon as power is applied. Allow

3 minutes for the booting process to complete.

Installation

1 2 3 4 5 6 7 8 9 10 11 12 ... 60 61

No comments

ADDER A.I.M. User's Guide Page 7