ADDER SmartView MultiScreen User's Guide download pdf (Page 10)

 







Remote control connections

The remote control unit can be used to provide manual switching between

systems.

To connect the remote control

1 Locate the remote control unit and the remote control cable. Attach the

smaller of the two cable connectors to the socket at the rear of the remote

control.

S / FLA

2 At the other end of the cable, attach the larger connector to the OPTIONS/

FLASH socket on the right side of the Adder unit rear panel.

Channel switching via RS232 control

The Adder SmartView Multiscreen Serial can be controlled by a remote RS232

serial device. To do this, the serial device must be connected to the OPTIONS/

FLASH port on the rear panel of the unit using an appropriate link cable.

S / FLA

The serial device must use the following speed/protocol settings:

1200 baud, 8 bits, no parity and 1 stop bit.

No handshaking is used by the SmartView Multiscreen Serial.

To perform the switching operation, simply send the character for the required

channel, for example ASCII ‘1’ (hex code 31) will select channel 1, ASCII ‘2’ (hex

code 32) will select channel 2 and so on. The SmartView Multiscreen Serial will

echo the ASCII character back to the sending device when the channel has been

changed.

Pin assignments for the OPTIONS/

FLASH port on the rear panel are

as follows:

Pin 9 = GND

Pin 10 = TXD

Pin 11 = RXD

Other pins to be left unconnected.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

No comments

ADDER SmartView MultiScreen User's Guide Page 10